Single-storey rear extension on a 1930s semi in Feltham TW13, planning drawings for London Borough of Hounslow approval

Feltham · TW13 · Hounslow

Hip-to-Gable Loft Conversion Drawings in Feltham TW13

Fixed-fee, MCIAT-chartered hip-to-gable loft conversion drawings for Feltham (TW13) homeowners — London Borough of Hounslow validation and local constraints handled from the start.

Feltham is an outer-west Hounslow suburb built largely between the wars and in the post-war decades, so the bulk of our work here is family-driven: single-storey rear extensions, side-return infills and loft conversions on 1930s semis and estate housing. Wide plots on roads such as Southern Avenue and Ashmead Road usually leave comfortable room to extend under permitted development while keeping the front elevation intact.

Where a plot sits near the St Dunstan's or Hanworth Park conservation areas, or on the lower ground close to the River Crane, we design to Hounslow Council's expectations from the outset — matching brick and roof lines, respecting the depth and height limits, and building in flood-resilient drainage detail so the application clears validation without an avoidable refusal.

Proposed floor plan

Feltham TW13

Feltham (TW13) — planning at a glance

Council: London Borough of Hounslow
Postcode district: TW13
Planning portal: View the Hounslow planning portal
Housing stock: Feltham is dominated by 1930s bay-fronted semis and post-war council-built estates, with generous rear gardens on roads like Southern Avenue and Glebelands Road. Plots are wide enough for single-storey rear extensions, side infills and hip-to-gable loft conversions without needing to touch the front elevation.
Article 4: London Borough of Hounslow does not publish its Article 4 directions to the national planning register, so permitted development rights in Feltham (TW13) can’t be confirmed from open data alone — we check the direction schedule with the council before recommending a route, as part of the fixed fee. No published householder Article 4 across Feltham's interwar and post-war estates — most rear and side extensions sit within permitted development, so the constraint is proximity to the Hanworth Park and St Dunstan's conservation areas rather than a borough-wide direction.
Conservation: Hanworth ParkSt Dunstan'sFeltham Town Centre
Sample streets: Southern Avenue · Glebelands Road · Ashmead Road · Browells Lane
Local constraints: Most of the housing stock is interwar/post-war semi-detached, so party wall agreements with immediate neighbours are the norm for rear and side worksThe St Dunstan's and Hanworth Park conservation areas tighten what is acceptable near the village core and parkland edgeFeltham Town Centre conservation area governs the busier commercial frontages rather than the residential streetsLow-lying ground near the River Crane and Longford River means some plots fall within Environment Agency flood zones and need a drainage-aware design

Planning in Feltham (TW13): what to know before you apply

There is no published householder Article 4 direction in Feltham, so most rear and loft projects proceed under permitted development. Watch the St Dunstan's, Hanworth Park and Feltham Town Centre conservation areas, and the flood constraint on plots near the River Crane, where PD rights and extension depths are more tightly read.

Typical Feltham housing stock

Feltham is dominated by 1930s bay-fronted semis and post-war council-built estates, with generous rear gardens on roads like Southern Avenue and Glebelands Road. Plots are wide enough for single-storey rear extensions, side infills and hip-to-gable loft conversions without needing to touch the front elevation.

Streets we regularly draw for in Feltham

Southern Avenue · Glebelands Road · Ashmead Road · Browells Lane

Hip-to-Gable Loft Conversion Drawings for Feltham (TW13) homes: the package and the process

Every hip-to-gable loft conversion drawings we prepare for an Feltham property is drawn to London Borough of Hounslow’s validation standards and tuned to the TW13 constraints above. Here is what the drawing package covers and how the process runs from first survey to approval.

Many London semi-detached and end-of-terrace houses, particularly the inter-war suburban stock that rings much of the city, were built with a hipped roof — sloped on all sides rather than finished with a flat gable end. That side slope wastes usable loft volume, and a hip-to-gable conversion reclaims it by extending the sloping hip out to a full vertical gable wall, squaring off the roof and opening up far more headroom along that side of the loft than the original roof shape allowed.

DrawingsDirect draws hip-to-gable conversions across outer and suburban London every week, usually alongside a rear dormer to maximise headroom over the stairwell. Because the hip-to-gable route is frequently permitted development, we check your eligibility first — and where a dormer, a mansard or a combination would use your roof better, we say so before you commit to a design. Every drawing set is produced by MCIAT-chartered architectural technologists, with structural calculations for the new gable wall coordinated in-house rather than farmed out to a separate engineer.

What is a hip-to-gable loft conversion?

A hipped roof slopes inward on all sides, including the end wall, rather than finishing in a flat vertical gable. A hip-to-gable conversion rebuilds that sloping hip as a vertical wall, in line with the existing side elevation below, squaring off the roof shape and creating a much larger, more usable loft footprint along that side without altering the rear or front roof slopes at all. It is one of the more straightforward roof alterations to build, because the new gable wall follows the line of the existing external wall rather than introducing a new roof form, which keeps both the design and the construction relatively contained compared with a full mansard rebuild.

Suits semi-detached and end-of-terrace houses with a hipped roof on the side elevation
Squares off the roof by rebuilding the sloping hip as a vertical gable wall
Leaves the front and rear roof slopes untouched

Is a hip-to-gable loft conversion permitted development?

Often, yes. For semi-detached and detached houses, permitted development rules allow more than one hip to be converted to a gable, provided the new roof does not exceed the height of the existing ridge and the total additional volume stays within the usual allowance — 50 cubic metres for detached and semi-detached homes. The new gable wall and roof materials should match the existing building, and the rules tighten or disappear entirely inside a conservation area or under an Article 4 direction, both of which we check before recommending the route. Where a previous owner has already extended into the roof or added a large outbuilding, the remaining volume allowance can be smaller than expected, so we always confirm the running total against your specific property rather than assuming the full allowance is still available.

Typical hip-to-gable loft conversion drawing packages
Conversion	Typical route	Structural scope	Fee from
Hip-to-gable only	Permitted development / LDC	New gable wall and rafter tie-in	£1,300
Hip-to-gable plus rear dormer	Permitted development / LDC where eligible	Gable wall plus dormer structure	£1,450
Hip-to-gable in a conservation area	Householder planning	New gable wall and rafter tie-in	£1,600

Also in Feltham TW13

Planning Permission Planning Drawings Architectural Drawings Building Regulations Drawings Loft Conversion Drawings Hip-to-Gable Loft Conversion Drawings across Hounslow Hip-to-Gable Loft Conversion Drawings across London

FAQ

Hip-to-Gable Loft Conversion Drawings in Feltham TW13 — FAQs

How much do hip-to-gable loft conversion drawings cost in London?+

A hip-to-gable conversion on its own typically starts around £1,300. Combining it with a rear dormer usually costs a little more, around £1,450, to cover the additional structural design — we confirm the fixed fee once we have surveyed your roof.

Will my semi-detached house qualify for permitted development?+

Often, but it depends on the volume already used, whether the property sits in a conservation area or under an Article 4 direction, and whether previous extensions have already used up the allowance. We check this free before recommending a route.

How long do hip-to-gable drawings take?+

Typically around 7 days from survey to a full drawing set in your online portal, whether the route is a Lawful Development Certificate or full planning.

Do I need an architect for a hip-to-gable conversion?+

No — as MCIAT-chartered architectural technologists we produce the same council-accepted drawings, with structural calculations coordinated in-house, typically at a lower fee than an architecture practice.

What building regulations apply to a hip-to-gable loft?+

The same core requirements as any loft conversion: a protected stairway or upgraded fire doors, a compliant means-of-escape window, structural calculations for the new gable wall and floor, and insulation upgraded to current Part L standards. We coordinate all of this alongside the planning or Lawful Development Certificate drawings.

Do I need planning permission for an extension in Hounslow?+

It depends on the area. The interwar semis of Osterley, Hounslow and Feltham often retain permitted development rights for rear extensions and lofts, while the Chiswick terraces and Bedford Park sit within conservation areas where those rights are removed. We check your address against the designations first and can confirm permitted development with a Lawful Development Certificate.

What extra control applies in Bedford Park?+

Bedford Park is one of West London's most tightly controlled conservation areas, with detailed control over materials, rooflines, windows and front elevations. A standard permitted-development dormer or cladding change usually won't apply; instead we design to the area's Arts-and-Crafts character and prepare a full householder application with the elevations and materials the council expects.

Does Heathrow or the river affect my Hounslow project?+

They can. Toward the west of the borough, aircraft-noise considerations near Heathrow may influence habitable-room and glazing design, and along the Thames at Strand-on-the-Green and Isleworth the flood zone must be addressed. We evidence these considerations within the application where they apply so the council can validate and approve without repeated revisions.

How long does Hounslow Council take to decide?+

Hounslow determines most householder applications within the statutory eight-week period once validated; Bedford Park, conservation and riverside cases can involve additional consultation. We prepare submissions to the council's validation checklist to avoid the drawing queries that cause most delays.

How much do planning drawings cost in Hounslow?+

We agree a fixed fee before starting, typically around 30% below an architect's fee for the same council-accepted drawings, with free redraws until Hounslow approves. A suburban Osterley extension and a Bedford Park application differ in the evidence required, so we quote once we understand your address and project rather than by the hour.

Free Fixed Quote

Get your free Feltham planning assessment

Tell us your Feltham (TW13) address and ambition — we'll confirm feasibility, local constraints and a fixed fee within one working day.